Monuments STEEL Montage- Und Gebrauchsanweisung Seite 22

trol unit. Sauna heaters with an
integrated are excluded from this
rule.
• If the sauna heater has in inte-
grated control, no external con-
trol unit is needed. The position
of the temperature sensor and the
overheating limiter are pre-deter-
mined by the internal construc-
tion of the device or have to be
done in the cabin based on the
instructions from the installation
manual.
Caution: Covering the heater
•
or an incorrectly filled stone con-
tainer represent a fire hazard.
The sauna heater must to be
checked for safe condition before
each commissioning (also at re-
mote start).
Every time before the sauna
•
is used, make sure that no ob-
jects are placed or forgotten on
the sauna heater
Caution: The high sauna
•
heater temperatures generat-
ed during operation can cause
burns.
The sauna heater is not intend-
•
ed for installation or set-up in a
niche, under a bench or under a
22
sloping roof.
Do not put the sauna heater into
•
operation when the air intake is
closed.
The cabin lighting and the cor-
•
responding installation in the
splash protected version must
comply with DIN EN VDE 0100
T 703. Therefore, only approved
sauna lamps with max. 40 W may
be used in connection with the
sauna heater.
Only a locally certified elec-
•
trician may connect the sauna fa-
cility (sauna heater, control unit,
lighting etc.) to a fixed mains
connection.
All electrical installations and all
•
connection lines that are installed
inside the cabin must be suitable
for an ambient temperature of at
least 170 °C. If single-wire cables
are used as connection lines, they
must be protected using a flexi-
ble metal tube connected to the
equipment grounding conductor.
Please see the table for the min-
imum cross-section of the con-
nection cable and the suitable
cabin size in relation to the power
input in kW.
When installing the sauna heat-
•
EN