Abicor Binzel MIG/MAG ROBO Betriebsanleitung Seite 39

MIG/MAG ROBO welding torch
12 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines
must be observed. Observe the regulations on the disposal of electronic scrap and dispose of
it at your local waste disposal site (e.g. recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take note of the
following information:
 11 Dismounting on page EN-18
12.1 Materials
This product is mainly made of metallic materials, which can be melted down in steel and iron
works and are thus almost infinitely recyclable. The plastic materials used are labelled in
preparation for their sorting and separation for later recycling.
12.2 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system.
These materials must be stored, transported and disposed of in suitable containers. Please
observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the consumables' manufacturer. Contaminated cleaning tools (brushes, rags, etc.)
must also be disposed of in accordance with the information provided by the consumables'
manufacturer.
12.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability
to recycle packaging materials is always considered during their selection.
12 Disposal
EN - 19