Installation Procedures - Hitachi SPX-WKT2 Installationsanleitung

2.3 INSTALLATION PROCEDURES

1 Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and then remove the remote controller
from holding bracket.
Groove
2 Attach the remote controller to holding bracket as follows.
Fix the holding bracket onto wall with screws(accessory) as shown right.
3 Cut the top of front cover and make a draw-out hole.
Lead the cable along the slot.
*Extended cable is prepared as an option. (SPX-WKT5M : 5m)
This cable can add until 2 pcs.
4 Insert the hooks of the controller to the holes on the top of the holding bracket. Push the lower part toward the holding bracket.
When the click sound is heard, the remote controller is attached to the holding bracket and the mounting work is finished.
Be careful not to pinch the cable when attaching it.
Remove the protection film from the liquid crystal display.
CAUTION
Pay attention so that the cable may not be bitten. It may cause a faulty operation.
Approx. 6mm
Slotted Screw driver
Figure seen from bottom side
Fix the holding bracket with
the mark "UP" upward.
Cut and make a draw-out hole.
Remove the protection film
Groove for attaching controller
- 3 -
Rear cover
Lead the cable along the slot.