Inhaltsverzeichnis
Werbung
Shimmering metallic
discoloration
Control panels
Cleaning the hob
surround
Procedure in the event of a malfunction
The hob does not work
E is flashing in all the
hotplate displays and a
signal is sounding
The hob has switched itself
off
The circuit breaker in your
household electrical circuit
trips when you switch on
the hob
Discoloration is caused by pan abrasion or the use of
unsuitable cleaning agents. This is very difficult to
remove. Use Hob Clean or Sidol for ceran + steel. Our
after sales service can remove discoloration, but will
charge for this service.
Always keep the control panels clean and dry. Food
residues and spills can impair the function of the
control panels.
Only use warm soapy water.
Do not use anything which is sharp or abrasive. The
glass scraper is unsuitable. The hob surround could
be damaged.
Neither lemon juice nor vinegar should be used for
cleaning the hob surround.
This could result in matt patches.
Malfunctions often have simple explanations and may
be easily rectified. Please read the following
instructions before calling the after sales service.
Check whether there is a power supply to the
appliance. Check whether the circuit breaker or fuse
on your electric appliance has tripped.
The control panel is very dirty, food has been spilt or
an object has been placed on the work surface. Clean
the control panel thoroughly or remove the object
from the work surface. Press the control panel
concerned. The flashing stops.
The main switch was touched inadvertently. Switch
the hob back on. Adjust the settings again.
Make sure that the power draw of all the appliances
switched on does not exceed your maximum
household electricity supply. Check whether the
circuit breaker triggers when you switch on another
hotplate.
55
Werbung
Kapitel
Inhaltsverzeichnis
