Preliminary Checks; Installation Dimensions - FAAC 390 Handbuch

3. ELECTRICAL EQUIPMENT (standards system)
Operators Operators
Photocells Photocells
Electronic equipment Electronic equipment
Key-operated push-button Key-operated push-button
Radio receiver Radio receiver
Flashlight Flashlight
To lay electrical cables, use adequate rigid and/or flexible tubes.
Always separate low voltage accessories from those operating at
230/115 V~. To avoid any interference, always use separate shea-
ths.
4. INSTALLATION OF AUTOMATION

4.1. PRELIMINARY CHECKS

To ensure safety and an efficient automation, make sure the following
requirements are met:
• The gate structure must be suitable for automation. In particular, make
sure it is sufficiently sturdy and rigid, and that its dimensions are in line with
those indicated in the technical specifications.
• Make sure that the leaves move properly and uniformly, without any
irregular friction during their entire travel.
• Check if hinges are in good condition.
• Make sure the travel limit mechanical stops are present. We advise you to
carry out any metalwork jobs before installing the automation.

4.2. INSTALLATION DIMENSIONS

Establish the installation position of the operator by consulting Fig. 4-5-6.
4.2.1. RECOMMENDED DIMENSIONS FOR INWARD OPENING
A (mm) A (mm)
60 ÷ 110 60 ÷ 110
Fig. 3 Fig. 3
110 ÷ 160 110 ÷ 160
160 ÷ 210 160 ÷ 210
110 ÷ 130 110 ÷ 130
210 ÷ 260 210 ÷ 260
260 ÷ 310 260 ÷ 310
310 ÷ 360 310 ÷ 360
60 ÷ 110 60 ÷ 110 190 ÷ 210 190 ÷ 210
110 ÷ 160 110 ÷ 160 230 ÷ 250 230 ÷ 250
160 ÷ 210 160 ÷ 210 290 ÷ 310 290 ÷ 310
210 ÷ 260 210 ÷ 260 310 ÷ 330 310 ÷ 330
As for 120° openings the curved arm must be fixed to the hole marked
with the letter "X"
4.2.2. RECOMMENDED DIMENSIONS FOR OUTWARD OPENING
Fig. 4 Fig. 4
A (mm) A (mm)
60 ÷ 110 60 ÷ 110
110 ÷ 160 110 ÷ 160
160 ÷ 210 160 ÷ 210 110 ÷ 130 110 ÷ 130
210 ÷ 260 210 ÷ 260
260 ÷ 310 260 ÷ 310
7
B (mm) B (mm) C max. (mm) C max. (mm)
730 730
720 720
710 710
700 700
690 690
670 670
650 650
600 600
540 540
510 510
B (mm) B (mm) C max. (mm) C max. (mm)
430 430
380 380
330 330
280 280
240 240
α (°) α (°)
90 90
120 120
120 120
Fig. 5 Fig. 5
α (°) α (°)
90 90
Fig. 6 Fig. 6