Electrical Installation; Maintenance - Nibe VPA 200/70 Montage- Und Wartungsanleitung

GB

Electrical installation

VPA 200/70 can be supplemented with an electric immer-
sion heater. Connection size R50. Max immersion heater
length 540 mm. Remove the lower front cover at installa-
tion.

Maintenance

The safety valve must be checked regularly, about four
times a year. If this does not happen then the safety valve
may malfunction and must be changed. The safety valve
sometimes releases a little water after hot water has been
tapped. This is because the cold water, which enters the
water heater to replace the hot water, expands when
heated causing the pressure to rise and the safety valve
to open.
Emptying
Draining the water heater takes place through the siphon
(with a hose) in the cold water connection (1). Drain the
boiler water section through the siphon (with a hose) on
the docking connection, outgoing to the external heat
source (4).
6
Hot water capacity
Charge power
4 kW
5 kW
7 kW
8.5 kW
10 kW
Technical specifications
Volume
Volume, outer jacket
Net weight
Heat transfer (55/45 10/45°C)
Heat content at 50 °C
Equivalent amount of hot water (40°C)
Max. immersion heater length
Max pressure, primary side
Max pressure, water heater
Part No.
Energy labelling
Supplier
Model
Energy efficiency class
Heat loss
Volume
Recovery
Leave the disposal of the packaging to the installer
who installed the product or to special waste
stations.
Do not dispose of used products with normal
household waste. It must be disposed of at a
special waste station or dealer who provides this type of
service.
Improper disposal of the product by the user results in
administrative penalties in accordance with current legis-
lation.
VPA 200/70
NL number T50 minutes
1,5 195
1,5 170
1,75 140
1,75 150
1,75 133
litre
litre
kg
kW
kWh
litre
mm
(bar)
(bar)
W
l
205
66
150
8,2
9,0
260
540
2,5
9,0
088 650
NIBE
VPA 200/70
E
150
271