STITCH FORMATION AND THREAD TENSION
Set the needle thread tension to be light enough to maintain
a needle loop at the tip of the needle on half the length of
one stitch.
There should be approximately 9 ounces (2.5 N) of needle
thread tension at the needle thread tension assembly and
2.5 ounces (0.7 N) of looper thread tension at the looper
thread tension assembly.
Use just enough needle thread strike-off to be set with
the „U"-shaped needle thread control eyelet to form an
adequate needle loop.
STICHBILDUNG UND FADENSPANNUNG
Stellen Sie die Nadelfadenspannung so ein, daß bei Bildung
einer halben Stichlänge eine ausreichend große Nadel-
fadenschlinge an der Nadelspitze gebildet wird.
Die Nadelfadenspannung an der Nadelfaden-Spannein-
richtung beträgt ca. 2,5 N (9 ounces), die Greiferfadenspan-
nung an der Greiferfaden-Spanneinrichtung ca. 0,7 N (2,5
ounces).
Ziehen Sie nur soviel Nadelfaden mit dem „U"-förmigen
Nadelfadenbügel ab, dass eine ausreichend große Nadelfa-
denschlinge gebildet wird.
25