English - Philips HD4428 Bedienungsanleitung

ENGLISH

6
Introduction
Dear customer, congratulations on acquiring the new Philips table grill. Your new grill with drip tray
allows you to prepare all kinds of tasty food almost smoke-free! Grilling with this appliance is extra
safe thanks to the safety shield and easy to use because of the large grilling surface.
General description (fig.1)
A Thermostat unit with mains cord
B Temperature control with on/off position and temperature light
C Base
D Drip tray
E Removable grilling plate
F Cool-touch handgrips
G Safety shield
H Thermostat unit socket
Important
Read these instructions for use carefully before using the appliance and save them for future
reference.
Check if the voltage indicated on the bottom of the appliance corresponds to the local mains
voltage before you connect the appliance.
If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid a hazard.
Do not connect the thermostat unit to the mains before having inserted the thermostat unit
into the appliance.
Make sure that the inside of the thermostat unit socket is completely dry before inserting
the thermostat unit.
Only use the thermostat unit supplied with the appliance.
Only connect the appliance to an earthed wall socket.
Do not let the mains cord hang over the edge of the table or worktop on which the
appliance is standing and keep the cord away from the hot surfaces of the appliance.
Put the appliance on a flat, stable surface with sufficient free space around it.
The drip tray must always be in place during cooking.
Always preheat the plate before putting any food on it.
The accessible surfaces may become hot when the appliance is in operation.
Keep the appliance out of the reach of children.
Do not let the appliance operate unattended.
Be careful of spattering fat when you are grilling fatty meat or sausages.
Always unplug the appliance after use.
Always switch the appliance off and remove the plug from the wall socket before removing
the thermostat unit from the thermostat unit socket.
Always clean the appliance after use.
Let the appliance cool down completely before removing the plate, cleaning the appliance or
putting it away.
Do not immerse the mains cord with thermostat unit in water or any other liquid.
Never touch the plate with sharp or abrasive items, as this will damage the non-stick coating.
Make sure you reassemble the plate properly after having removed it.
This appliance is only intended for indoor use and should not be used outdoors.