Software-Installation - Velleman CAMIP7 Bedienungsanleitung

6. Hardware installation and operation
Refer to the illustrations on page 2 of this manual.
• Choose the location for the camera, keeping following guidelines in mind:
o do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
o avoid mounting the camera near high electro-magnetic fields.
o do not aim the camera at the sun or other extremely bright objects or reflections (e.g. metal
doors).
• Use the mounting bracket [7] to determine the location of the mounting holes. Drill the holes and
secure the bracket [7] using 3 screws.
• Attach the camera to the mounting bracket [7] with the camera bolt [5].
• Slide the sunshield [4] in place.
• Point the camera towards the zone of interest and tighten the position bolt [6].
• Connect the antenna [8] to the antenna connector and/or connect a network cable (included) to
the RJ45 jack [9]. If in doubt, contact your local network service provider.
Note: it is possible to connect the camera straight to the RJ45 port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
• Plug the DC connector of the power adaptor into the 5VDC input jack [10]. Only use the included
adaptor or one with the same specifications.
• Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Note: it takes about 30s for the camera to initialise.
7. Software installation
• Insert the included CD-ROM into a suitable computer system (not incl.).
System requirements: CPU ≥ 2.06 GHz / memory ≥ 256MB / network ≥ 10 MB / video card ≥
64MB memory / recommended OS: Windows 2000 or XP / Mac.
Windows
• Locate the software installer IPCamSetup.exe and double click it.
• Follow the instructions on the screen. Click Next to start the software installation.
13.01.2011
CAMIP7
4
©Velleman nv