Using The Cas 100 With External Media Players Or Mixers; Installing The Rear Security Cover; Mounting; Technical Specifications - Klein + Hummel CAS 100 Bedienungsanleitung

■ Using the CAS 100 with External Media Players or Mixers

The Upper Slot and Lower slot signal plus and signal minus terminals may be used to feed the CAS 100 with any
other unbalanced line level audio source. Simply disconnect the wires provided on the terminal blocks provided and
make a cable which attaches to the output of the audio device being connected. Use the Upper Slot or Lower Slot
knob on the front panel to trim the input level to the mixer from the external audio device.

■ Installing the Rear Security Cover

The cable connections to the rear of the unit may be secured against curious hands by installing the rear cable
security cover. Use the included screws to attach the cover. If desired, use security head screws to discourage
tampering. Collect all cables into a single bundle and route out through the grommeted hole in the cover.

■ Mounting

The CAS 100 ships with rubber feet on the bottom and may be placed directly on a shelf. The included rack ears
may be used to mount the CAS 100 in a standard 19" equipment rack, taking up slightly larger than 2 vertical rack
spaces. Alternately, the rack ears may be removed and mounted to the sides of the CAS 100 as flange mounts
allowing the CAS 100 to be attached underneath a shelf or table.

■ Technical Specifications

Electronics
Frequency Response
Option slots
Option slot DC power available
Option slot audio input
Aux input (3 of 4 inputs)
Mic input (4 of 4 inputs)
Power amplifier
Operating temperature
Mute
Rec output
Displays and Mains Power
Displays and indicators: power on
Input overload
Power Requirements
Power consumption - Idle
Power consumption - Full
Power connection, AC
Power connection, DC
Mechanics
Height x width x depth
Weight
Mounting
Security
Operating Manual CAS 100
Quantity (2), compatible to Sennheiser evolution wireless receivers
12 V DC source, terminal block, max. 2 A amps total loaded for both slots
-10 dBV to +6 dBV, unbalanced, terminal blocks
-10 dBV to +6 dBV, unbalanced, stereo RCA/cinch
-40 dBu nominal, balanced, XLR/1/4" combo jack
30 Watts/Channel x 2 channels (mono sum each channel),
4-Ohm minimum load impedance
0°........+ 40° C (32.0 ° F.......104.0° F)
Dry contact closure, open circuit muted, terminal block
-10 dBV nominal, unbalanced, Stereo RCA/cinch, mono sum
100 – 230 V, 50-60 Hz, max 120 Watts, IEC power cord
Included IEC cable for Edison, 2-pin Euro sockets and UK sockets
12 V DC input, terminal block, 10 Amps
110 mm 2,5 U x 483 mm x 372 mm, 4 3/8'' x 19'' x 14 6/8''
Included removable rack ears, requires 2+ rack spaces
Removable rear cover with security screws
English
CAS 100
30 Hz – 18 kHz
or K+H CD players
Red LED
Red LED "Flashing"
30 VA
550 VA
9.6 kg (21.16 lbs)
7