Installing A Sennheiser Wireless Microphone Receiver - Klein + Hummel CAS 100 Bedienungsanleitung

■ Installing a Sennheiser Wireless Microphone Receiver

Any Sennheiser Evolution series wireless microphone receiver may be installed in either or both of the two
universal option slots.
Remove the four screws holding one of the
blank plates in position.
Attach the adhesive rubber spacers which
shipped with the CAS 100 to 4 places under
the rack ear tabs (evolution wireless G2
series only).
Attach the two rack ears which shipped with
the CAS 100 (located inside the option slot
behind the blank plate) to the wireless
receiver with two screws on each side.
Install the AM 2 antenna extension kit.
Mount the telescopic antennas to the rear
security cover.
Insert the wireless microphone receiver into
the option slot.
Find the plate with the oval hole cut-out
from in the included accessory kit.
Re-install the four screws into the new cover
plate with the hole cut-out.
Plug the audio and DC cable jumper into
either the Upper Slot or Lower Slot jack on
the rear of the CAS 100 as appropriate.
Operating Manual CAS 100 English 6