Connecting A Music Player; Using Both A Microphone And Music Player; Adjusting The Tone Control; Recording A Speech Or Presentation - Klein + Hummel CAS 100 Bedienungsanleitung

■ Connecting a Music Player

To connect a DVD, MP3 or CD player to the CAS 100, use an adapter cable with RCA (cinch) connectors and plug
them into the input labelled Aux In L/R. Turn the Master Volume to the second line on the dial. Start playing the
loudest music you have and turn up the input knob over the Aux Input until the red Input Overload light begins to
flash. Turn the volume back down until the light stops flashing and then turn it down one line more. Turn up the
Master Volume until the sound is loud enough.

■ Using both a Microphone and Music Player

Turn the Master Volume all the way down to the far left position. Plug the microphone into the Mic In connector.
Talk into the microphone and turn up the knob over the Mic In until the red Input Overload light begins to flash.
Turn the knob back down until the red light stops flashing. Plug the DVD or CD/MP3 player into the Aux In
connectors. Play back the loudest music on the player and turn up the knob over the Aux In until the red lnput
Overload light begins to flash. Turn the knob back down until the red light stops flashing. Turn up the Master
Volume until the music is loud enough. Stop the music and speak into the microphone.
When the microphone is too loud:
When the microphone is too soft:
If it is not possible to get the microphone or the CD loud enough: Turn all the knobs all the way down to the left and
start the instructions at this section again.

■ Adjusting the Tone Control

The CAS 100 has been optimized at the factory so that for most media and voices the Bass, Mid and Treble controls
should be set at their centre detent position. Turning up the Mid control and turning down the bass control can
make voices easier to understand. Turning up the Treble control can make the speaker sound brighter in a big room
or outdoors.

■ Recording a Speech or Presentation

The Line Out connection may be attached to an external recording device. The audio signal at this output is a mix of
the microphone and music player inputs. The level is not affected by the Master Volume control.

■ Installing the K+H CD Player

Refer to the installation instructions included with the CD player. The method of installation is similar to the
installation of the wireless microphone receiver illustrated below.

■ Using the K+H CD Player

With the Power turned on, turn the Master Volume to the second line on the dial. Start playing the loudest music
you have and turn up the input knob for either the Upper or Lower Slot until the red Input Overload light begins to
flash. Turn the Input level back down until the light stops flashing and then turn it down one line more. Turn up the
Master Volume until the sound is loud enough.
Operating Manual CAS 100
Turn the Mic In down one line at a time until the level is correct.
Turn the Master Volume up one line and turn the Aux In down one line. Try
listening to the microphone again.
English 5