Compatible Accessories; Troubleshooting; Ec Declaration Of Conformity; Certification - Klein + Hummel CAS 100 Bedienungsanleitung

■ Compatible Accessories

CDP3 CD player capable of MP3 disks designed for mounting in the CAS 100 option slots.
Sennheiser evolution Wireless microphone receiver series offering flexible frequency selection and superior
wireless performance designed for mounting in the CAS 100 option slots. Requires AM2 accessory.
AM2 Antenna extension kit for mounting the evolution wireless antennas externally on the
CAS100 rear security cover. (Article number: 009912)

■ Troubleshooting

Issue
No Sound
No Sound
Distorted Sound
Doesn't Sound Good
AC Light Not Glowing Red

■ EC Declaration of Conformity

This equipment is in compliance with the essential requirements and other relevant provisions of Directives
2004/ 108/ EG and 2006/ 95/ EG. The declaration is available on the internet site at www.klein-hummel.com.
Before putting the device into operation, please observe any respective country-specific regulations.

■ Certification

CAN/CSA-C22.2 No. 60065:2003, UL60065:2004 und EN60065/A1:2005

■ Recycling

Attention to product quality in the design phase ensures, firstly, that products have a long life and that, secondly,
all parts of a product may be reused or recycled at the end of that life. An extensive product servicing network
ensures that products can be repaired in the event of the premature failure of a part, or as a way to prolong the life
of a product that would otherwise be considered a candidate for landfill. Eventually there comes a time when a
product is considered beyond repair (for economic reasons or lack of parts), so the parts must be disposed of in a
suitable manner. The disposal should conform to local environmental regulations and be conducted in an
authorized recycling facility. This product consists of some or all of these components:
Item
Power Amplifier
Packing Material
User Manuals and Sales Literature
Operating Manual CAS 100
Possible Causes
Mute contact / fire alarm link active. Check connection. For testing
purposes apply a short to the mute contacts.
Power switch not turned on. Input level knob turned down. Master
Volume turned down.
When red Input Overload light is flashing turn down the Input level
knob.
Check to be sure the Tone Control knobs for Bass, Mid and Treble are
set to their center (detent) position.
Power cable not plugged in or no power at outlet. Check the fuse in
the unit next to the AC cord plug.
Material
Steel, Plate, electronic devices
Cardboard, wood and/or plastics
Paper and cardboard
Recycling Instructions
Recycling only in authorized
recycling plants
Separate materials then recycle
Recycle
English 8