Rear Panel Picture - Klein + Hummel CAS 100 Bedienungsanleitung

Master Volume The Master Volume control sets the loudness of all inputs, microphones and music players
connected to the mixer. To turn down just one Input without changing the volume of the
others, use the Input knobs to do so.
Bass Use this adjustment to provide more low end to the woofer or to take away low end if the
sound has too much bass.
Mid Use this adjustment to adjust the mid range frequencies of the mixer to make it sound more
full or more thin depending on the media being played.
Treble Use this adjustment to make the speaker sound more or less bright and sparkly.
Upper Slot Used to adjust the input level of the optional device, either CD player or wireless microphone
receiver, installed in the upper option slot.
Lower Slot Used to adjust the input level of the optional device, either CD player or wireless microphone
receiver, installed in the lower option slot.
Mic In Used to adjust the input level of the hard wired Mic input on the rear of the mixer.
Aux In Used to adjust the input level of the hard wired aux media input on the rear of the mixer.
Input Overload The input overload light flashes when one of the input level knobs is turned up too high. Turn
them all down and begin turning them up one at a time until the light flashes. Then turn the
knob which made the light flash down slightly until the input overload light stops flashing.
On Indicates that the unit is receiving power and the Power switch is turned on.
Power Used to switch the power to the unit on and off. The up position is on.

■ Rear Panel Picture

(shown with optional CD Player and wireless mic receiver installed into the option slots)
Operating Manual CAS 100
CAS 100 Rear View
CAS 100 Rear Panel Close-up
English 3