Specifications - Makita HR3540C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Lamp
3-1. Adjusting dial
4-1. Lock button
4-2. Pointer
4-3. Change lever
5-1. Lock button
5-2. Change lever
5-3. Pointer
6-1. Pointer
6-2. Change lever

SPECIFICATIONS

Concrete
Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For Model HR3540C
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
6-3. Lock button
7-1. Power-ON indicator lamp (green)
7-2. Service indicator lamp (red)
8-1. Side grip
9-1. Bit shank
9-2. Bit grease
10-1. Bit
10-2. Chuck cover
11-1. Bit
11-2. Chuck cover
12-1. Change lever
Model
Tungsten-carbide tipped bit
Core bit
Steel
Wood
-1
)
Overall length
Net weight
Safety class
) : 93 dB(A)
pA
) : 104 dB(A)
WA
HR3540C
5.2 kg
ENE044-1
Vibration
The vibration
determined according to EN60745:
ENF002-1
Work mode : chiseling function
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : hammer drilling into concrete
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG102-3
For Model HR3541FC
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
4
12-2. Lock button
12-3. Pointer
13-1. Depth gauge
13-2. Clamp screw
15-1. Blow-out bulb
18-1. Screws
19-1. Connector
20-1. Crank cap cover
20-2. Screws
21-1. Screws
24-1. Connector
HR3541FC
35 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
439 mm
5.6 kg
/II
total value (tri-axial
) : 12.5 m/s
h,CHeq
2
) : 18.0 m/s
h,HD
2
2
) : 2.5 m/s
h,D
2
) : 91 dB(A)
pA
) : 102 dB(A)
WA
Wear ear protection
ENG215-2
vector sum)
2
ENG303-2
2
ENG301-1
ENG102-3