Specifications - Makita BO4565 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch
2-1. Velcro sandpaper
2-2. Base
3-1. Velcro sandpaper
3-2. Base

SPECIFICATIONS

Orbits per minute (min
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sanding of large surface of
wood, plastic and metal materials as well as painted
surfaces.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745-2-4:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
4-1. Base
4-2. Velcro sandpaper
5-1. Dust bag
6-1. Groove
6-2. Front fixing cardboard
Model
Pad size
-1
)
Net weight
Safety class
) : 81 dB(A)
pA
) : 92 dB(A)
WA
value (tri-axial vector
2
) : 4 m/s
h
2
ENE052-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENF002-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG102-2
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Finishing Sander
Model No./ Type: BO4565
are of series production and
ENG211-1
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
sum)
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by our authorised
ENG901-1
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
3
6-3. Front side of paper dust bag
7-1. Claws
7-2. Upper part
8-1. Notch
8-2. Guide
BO4565
112mm×190mm
14,000
219 mm x 112 mm x 139 mm
1.2 kg
/II
Corporation as
ENH101-12
the responsible