Control Board - Futurelight PSC-1200 MK-2 Bedienungsanleitung

Control Board

The Control Board offers several features: you can simply set the starting address, switch on and off the
lamp, run the pre-programmed program or make a reset.
The main menu is accessed by pressing the Enter-button for 3 seconds until the display starts flashing.
Browse through the menu by pressing the Up-button. Press the Enter-button in order to select the desired
menu. You can change the selection by pressing the Up-button. Confirm every selection by pressing the
Enter-button. You can leave every mode by pressing the Exit-button. The functions provided are described in
the following sections.
Default settings shaded.
Main
Sub menu
menu
ADDR
0 MODE
RUN
DISP
OPEN
ONLI
1 LAMP
DELA
RPAN
RTIL
16BI
2 SET
REST
LODA
VER
LADJ
3 ADJU
TEST
MATI
LATI
4 TIME
CLMT
CLLT
STEP
SC01
5 EDIT
~
SC48
Extension
VALU A001 ~ AXXX
SLAV ON/OFF
EBOC ON/OFF
AUTO ALON
MAST
SOUN ALON
MAST
VALU D-00 ~ D-30 (DXX)
D-00
RDIS ON/OFF
CLDI ON/OFF
ON/OFF
ON/OFF
D–00 ~ D-59, D-15
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
V-1.0~V-9.9
ON/OFF
T–01 ~ T–30
0000~9999 (hours)
0000~9999 (hours)
ON/OFF
ON/OFF
S–01 ~ S–48
C01 ~ C30 01XX (00~FF)
30XX (00~FF)
TIME (sec.) T – – X (1~9)
CNIN ON/OFF
42/99
Display
DMX address setting
(SLAV)
Change DMX address via
(AU-A) Automatic Program Run
(AU-M) Automatic Program Run
(SO-A) Sound-controlled Program Run
(SO-M) Sound-controlled Program Run
Display the DMX 512 value of
Shut off LED display
Lamp on/off via controller
Restore factory settings
Test function of each channel
Fixture running time
Lamp running time
Steps of Program Run
Edit the channels of each scene
Time for each scene
Edit program via controller
00024217.DOC, Version 1.4
Function
Slave setting
external controller
in Stand Alone
as Master
in Stand Alone
as Master
each channel
Reverse display
Lamp on/off
Delay lamp on
Pan Reverse
Tilt Reverse
Switch 16 bit/8 bit
Reset
Software version
Lamp adjustment
Service-function
Clear lamp time