Assembling The Travel Sensor; Mounting The Positioner; Checking The Mounted Assembly; Remote Mounting To Linear Or Quarter Turn Actuators - Gemü 1436 cPos Kurzanleitung

2.2.3

Mounting the positioner

Place the adapter 4 on the shaft of the
G
travel sensor.
Place the positioner with the travel sensor
G
and mounting bracket onto the actuator.
The adapter lug 5 must engage in the
G
actuator shaft groove.
Attach the mounting bracket 1 to the
G
actuator with the enclosed screws.
1
View X with adapter
3
View X only travel sensor
Travel sensor with marking
4
5
View X
0° 45°
90°
2
2.2.4

Checking the mounted assembly

Connect the positioner to power and air
G
supply.
The following message is displayed:
G
NoInit
The mounted actuator can be moved to the
OPEN and CLOSED positions using the +
and - keys.
The displayed valve position must be
between 0 % and 100 %.
If the displayed valve position is not within
the range of 0 % and 100 %, the mechanical
mounting must be checked again.
2.3 Remote mounting to linear or
quarter turn actuators
2.3.1

Preparation of the valve actuator

See chapter 2.1.1 or 2.2.1.
2.3.2

Assembling the travel sensor

See chapter 2.1.2 or 2.2.2.
2.3.3 Checking the mounted assembly
See chapter 2.2.4.
2.3.4

Mounting the mounting bracket

Push the positioner connection adapter
G
through the hole in the mounting bracket
and attach it with the enclosed nut.
Use the bolt holes and appropriate fi xings
G
to attach the mounting bracket securely.
Ensure adequate stability of the base
used for attachment.
The positioner must be protected
against mechanical stress by the
operator.
Do not use the positioner as a climbing
support.
2.3.5

Connecting the travel sensor

The 5-pin M12 travel sensor plug must
be connected to the 5-pin M12 positioner
socket.
9 / 24
XX.X%
CAUTION
1436 cPos
®