Maintenance And Modifications - Klarstein 10032037 Handbuch

EN
24
Modell 10032038
1 In standby mode: press and hold
for 3 seconds, power is turned on,
the machine starts. In the boot state:
short press this button, LED lights on/
off switch. In the boot state: press the
button for 3 seconds, the power is
off, the whole machine is closed.
2 Display the measured temperature
inside the wine cooler.
3 Each time, the temperature inside
will drop 1°C, until reduced to a
minimum, and then a return to the
highest temperature.

MAINTENANCE AND MODIFICATIONS

Defrosting
Your wine cellar is designed with "Auto-cycle" defrost system. During "Off-cycle" the
refrigerated surfaces of the wine cellar defrost automatically. Defrost water from the wine
cellar storage compartment drains automatically and part of it goes into a drainage
container, which is located at the back of the wine cellar next to the compressor. The
heat is transferred from the compressor and evaporates any condensation that has
collected in the pan. Part of the remaining water is collected within the wine cellar for
humidity purposes. This system enables the creation of the correct humidity level inside
your wine cellar required by the natural cork to maintain a long lasting seal.
Notes: The water collected by condensation, is therefore recycled. Under extremely
dry environmental conditions, you may have to add some water into the water
container provided with your wine cellar.