EN
26
Reversibility of the Door
1
To put the cabinet on open operation place;
2
The door opened to the maximum angle, take off the decorative nail on opposite
side (Drawing 1);
3
To disassemble the pivot core of upper and lower door hinge by the inner six angle
screwdriver (Drawing 2);
4
To suck out the door shaft core from the two ends of the top of the door by magnet
(Drawing 3).
5
Take away the door from cabinet after discharge the door core.
6
Discharge the upper and lower door hinge by screwdriver (Drawing 4).
7
To assemble the door on the opposite side with accessories in accessory bag.
1 Decorative nail
2 M4 six angle screwdriver
3 M4 door limit screw
4 Pincer
5 Door core
6 Slot type screwdriver
7 Upper door hinge
8 Lower door hinge
9 M5 six angle screwdriver
10 Lower door hinge
1 1 Knife