Troubleshooting - Klarstein 10032037 Handbuch

Handle Installation Method
1 Take out handle from cabinet, then
take out four pcs 4*35 screws from
accessory bag.
2 Pull open door seal from the side of
door, then insert screws into the 2
handle holes on side of door, then
put the screws alignment the hole of
handle , tighten the screws by Phillips
screwdriver then compress the door seal
3 If the screws holes of the handle don't
match perfectly with the holes of the
door, please use the electric drill to drill
the holes of the door a bit big (in surface
side), in order to install the handle
perfectly .

TROUBLESHOOTING

Problem Possible Cause and Suggested Solution
Wine cellar Not plugged in.
does not
The appliance is turned off.
operate.
The circuit breaker tripped or the fuse is broken.
Wine cellar Check the temperature control setting.
is not cold
External environment may require a higher setting.
enough.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The light does Not plugged in.
not work.
The circuit breaker tripped or a blown fuse.
The bulb is out of order.
The light button is "OFF".
EN
27