Herunterladen Inhalt Inhalt Diese Seite drucken

Operating Noises - Klarstein 10032037 Handbuch

Vorschau ausblenden Andere Handbücher für 10032037:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
EN
22

Operating Noises

To reach the desired temperature settings, wine cellars, like all wine cellars operating
with compressors and fans, may produce the following types of noises. These noises are
normal and may occur as follows:
• Gurgling sound - caused by the refrigerant flowing through the appliance's coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the
refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the wine cellar.
Loading the Wine Cellar
• You may load your wine bottles in single or double rows while taking note of the following:
if you do not have enough bottles to fill your wine cellar, it is better to distribute the load
throughout the wine cellar so as to avoid "all on top" or "all below" type loads.
• Do remove or relocate adjustable wooden shelves to accommodate larger type
of bottles or increase the capacity of the cellar by stacking the bottles up when
necessary. (See removing shelves)
• Keep smalls gap between the walls and the bottles to allow air circulation. Like an
underground cellar air circulation is important to prevent mould and for a better
homogeneous temperature within the cellar.
• Do not over load your wine cellar to facilitate air circulation.
• Avoid obstructing the internal fans (located inside on the back panel of the wine cellar).
• Do not slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the wine cellar
to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct
air circulation.
• Do not move your wine cellar while it is loaded with wines. This might distort the
body of the wine cellar and cause back injury.
Types of Regulation
Please note that depending on the loading and settings chosen it takes about 24 hours
for the wine cellar to see the temperature stabilizing. During this time LED seems to
move erratically in particular,It is normal and this process occurs whenever the setting is
modified and/or whenever a large amount of bottles are added to the cellar.
• 10032037: Both built-in and free-standing type, sensor touch controller and LED display
• 10032038: Built-in type, LED displayer
These wine cellars reproduce the ideal conditions for wine storage, at a constant
recommended temperature of 12°C. T Unless stated by the wine maker on the bottle,
We recommends 7°C for your champagne, 12°C for whites and 18°C for reds.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

10032038

Inhaltsverzeichnis