Operation - Makita TW0200 Bedienungsanleitung

For socket without O-ring and pin
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
For socket with O-ring and pin
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto the
anvil of the tool so that the hole in the socket is aligned
with the hole in the anvil. Insert the pin through the hole
in the socket and anvil. Then return the O-ring to the
original position in the socket groove to retain the pin. To
remove the socket, follow the installation procedures in
reverse.
Fig.4
Hook
The hook is convenient for temporarily hanging the tool.
This can be removed without using a tool. This can be
installed on either side of the tool.
Installing and removing hook
Fig.5
Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal
procedure in reverse.

OPERATION

CAUTION:
Always hold the tool only by the handle when
•
performing an operation. Do not touch the metal
part.
Fig.6
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
200
M16X80
180
160
140
120
100
M12X80
80
60
M10X80
40
20
0
1 2
Fastening time (S)
004238
M16
M12
M10
4
3
High tensile bolt
200
M12X80
180
160
140
M10X80
120
100
80
60
40
20
0
1 2
Fastening time (S)
004239
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
NOTE:
When fastening screw M10 or smaller, carefully
•
adjust pressure on the switch so that the screw is
not damaged.
Hold the tool pointed straight at the bolt or nut
•
without applying excessive pressure on the tool.
If you fasten the bolt for a time longer than shown
•
in the figures, the bolt or the socket may be
overstressed, damaged, etc. Before starting your
job, always perform a test operation to determine
the proper fastening time for your bolt. Especially
for the bolt over than M10, perform the above test
operation to prevent the trouble on socket or bolt,
etc.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. Voltage
Voltage drop will cause a reduction in the fastening
•
torque.
2. Socket
Failure to use the correct size socket will
•
cause a reduction in the fastening torque.
A worn socket (wear on the hex end or square
•
end) will cause a reduction in the fastening
torque.
3. Bolt
Even though the torque coefficient and the
•
class of bolt are the same, the proper
fastening torque will differ according to the
diameter of bolt.
Even though the diameters of bolts are the
•
same, the proper fastening torque will differ
according to the torque coefficient, the class of
bolt and the bolt length.
5
M12
M10
5
3 4