Hilti AG 100-8 series Original Bedienungsanleitung Seite 32

Trouble or fault
The power tool doesn't start.
The tool doesn't work.
The tool does not achieve full
power.
11 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
12 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
13 EC declaration of conformity
Manufacturer
Hilti Aktiengesellschaft
Feldkircherstrasse 100
9494 Schaan
Liechtenstein
We declare, on our sole responsibility, that this product complies with the following directives and standards.
Designation
Type designation
Generation
Year of design
Type designation
Generation
Year of design
Type designation
Generation
Year of design
Type designation
26
Possible cause
The supply cord or plug is defec-
tive.
The carbon brushes are worn.
The tool has been overloaded.
The extension cord conductor
cross section (gauge) is inade-
quate.
Angle grinder
AG 100-7 (S/D)
03
2013
AG 100-8 (S/D)
03
2013
AG 115-7 (S/D)
03
2013
AG 115-8 (S/D)
Action to be taken
▶ Have the supply cord and plug
checked by a trained electrical
specialist and replaced if
necessary.
▶ Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
▶ Release the on/off switch and
then press it again. Then allow
the power tool to run under no
load for approx. 30 seconds.
▶ Use an extension cord with
an adequate conductor cross
section.