Conformity And Approval; Power Supply; Operation - Monacor ATS-10TM Bedienungsanleitung

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL de­
clare that the transmitter ATS­10TM com­
plies with the directive 2014 / 53 / EU . The EU
declaration of conformity is available on the
Internet:
www .monacor .com
The transmitter is generally approved for op­
eration in EU and EFTA countries; it is licence-
free and requires no registration .

4 Power Supply

The transmitter is supplied with power via the
two supplied rechargeable NiMH batteries . In­
stead of the rechargeable batteries it is also
possible to use two non­rechargeable 1 .5 V
batteries of size AA .
1) Slightly press the grooves on the battery
compartment cover (11) while pulling the
cover downwards at the same time .
2) Insert the batteries with the positive and
negative connections as printed in the
compartment .
3) Replace the cover and make sure it en­
gages .
Never put batteries in the house­
hold waste; always take them to a
special waste disposal, e . g . collec­
tion container at your retailer .
Hint: For quick and easy charging of the recharge­
able batteries used in ATS­10R and ATS­10TM,
MONACOR offers special chargers:
– charging station ATS­10PS for charging the bat­
teries of up to 2 units at the same time
– charging case ATS­12C for charging the batteries
of up to 12 units at the same time
– charging case ATS­30C for charging the batteries
of up to 30 units at the same time
8

5 Operation

1) Screw the supplied antenna (1) into the
threaded jack ANT . (5) .
2) The integrated microphone (4) or the sup­
plied tie clip microphone may be used .
When using the tie clip microphone, con­
nect it to the jack MIC . (6) [the integrated
microphone is switched off in this case] .
Place the supplied windshield on the tie
clip microphone . Fasten the microphone to
your clothes (e . g . tie, lapel) via its clip .
3) With the channel selector switch CHANNEL
SELECT (9), select the channel for transmis­
sion from the 16 transmission channels:
Use a narrow object, e . g . screwdriver, to
set the switch to one of the 16 positions .
Example:
In this switch position,
channel 1 is selected .
Set the receiver(s) to the same channel .
4) Use the clip (10) to fasten the transmitter to
your clothes, e . g . belt .
5) To switch on the transmitter, set the switch
(7) to the left stop to ON . (In the mid­po­
sition STAND BY, the transmitter is also
switched on but it is mute, i . e . no sound
is transmitted .)
After switching on, the LED BATT . LOW
(8) briefly shows red before permanently
showing green . However, if it permanently
shows red, the (rechargeable) batteries are
almost discharged and must be recharged
or replaced .
6) Switch on the receiver(s) .
7) Adjust the desired volume for the audio
signal transmitted with the control VOL (2) .
Adjust the desired reproduction volume on
the receiver(s) with the volume control .