Altering An Option Or A Running Programme; Interrupting A Programme; Cancelling A Programme - Electrolux WTGL3VIT200 Gebrauchsanleitung

14 electrolux
Press the button 8 again to restart the pro-
gramme from the point at which it was in-
terrupted
If you have chosen a delayed start with but-
ton 9, the machine will begin the count-
down.
If you set an incorrect option, the yellow pi-
lot light of the button 8 blinks for 3 times.
The display shows the message Err for
some seconds.
SETTING THE DELAY START (BUTTON
9)
Press this button again an again to set the
required delay.
The display shows the set delay time value
(up to 20 hours) for some seconds, then it
shows the duration of the programme
again.
Set the delay before you press the button
8.
You can delay the wash programme can be
delayed from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum
of 20 hours.
Adding items after you have set the de-
lay (throughout the delay time the door will
be locked):
• Press the button 8 to put the machine in
pause
• Add the laundry, close the door .
• Press the button 8 again.
Setting the delayed start:
• Set the programme and the required op-
tions.
• Set the delay start.
• Press the button 8: the appliance starts
its hourly countdown.
The programme will start after the selec-
ted delay has expired.
Cancelling the delayed start:
• Press the button 8 to set the washing
machine to PAUSE;
• Press the button 9 once until the display
shows the symbol
• Press the button 8 again to start the pro-
gramme.
You can change the set delay only after
you set the washing programme again.
The Delay Start can not be selected with
DRAIN programme.
';
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries it out. Before
you make any change, you must press the
button 8 to pause the appliance.
Changing a running programme is possible
only by resetting it.
Turn the programme dial to
the new programme position.
Press the 8 button again to start the new
programme. The washing water in the tub
will not emptied out.

INTERRUPTING A PROGRAMME

Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing light starts blinking. Press the button
again to restart the programme.

CANCELLING A PROGRAMME

Turn the selector dial to
gramme which is running. Now you can se-
lect a new programme.
OPENING THE DOOR
When the machine is working and through
the delay time, the door is locked.
If, for any reason, it is necessary to open it,
firstly press the button 8 to set the machine
to pause
If the light C after a few minutes goes off,
the door can be opened.
If the light C stays on and the door remains
locked, this means that the machine is al-
ready heating or that the water level is too
high. In this case the door can not be
opened.
If you cannot open the door but you need
to open it, turn the programme dial to
switch the machine off. After a few minutes
the door can be opened (pay attention to
the water level and temperature !) .
After closing the door, it is necessary to set
the programme and the options again.
Press button 8 to start the programme
again.
AT THE END OF THE PROGRAMME
The machine stops automatically. The pilot
light of button 8, the pilot lights A and C go
off. A blinking will appear on the display.
and then to
to cancel a pro-
to