Starting An Iron Aidtm Programme - Electrolux Iron AidTM EDI97170W Benutzerinformation

12 electrolux
Important: If in doubt, always select a
lower steam level first until you have
more experience with load volumes, fab-
ric types and the corresponding opti-
mum steam level. If too high a steam
level is selected, garments may lose
their shape. If too low a steam level is
selected, creases may remain.
Selecting additional functions
The additional functions available for the
Iron Aid programmes are BUZZER (BUZ-
ZER), DELAY (DELAY) and the CHILD LOCK.
BUZZER (BUZZER)
The appliance is supplied with the BUZZER
function activated. When the drying cy-
cle has finished, an intermittent acoustic sig-
nal will sound. Each time a button is press-
ed or a programme is changed using the
programme knob, an audible signal is also
set to sound. The button is used to switch
the function on or off. When the function is
active, the BUZZER
the display.
DELAY (DELAY)
With the DELAY button, you can delay
the start of a programme by between
30 minutes (
maximum of 20 hours (
).
STARTING AN IRON AID
Press the START/PAUSE button. The pro-
gramme is started. First, the drying phase in-
dicator appears in the display. The display
will also show the programme duration for
the selected Iron Aid programme, not includ-
ing the additional drying phase. With wet
laundry, after a few minutes the appliance
will show the correct programme duration
for the Iron Aid programme including the pre-
ceding drying programme. As soon as the
symbol appears in
) and a
TM
PROGRAMME
1. Select the programme and additional
functions.
2. Press the DELAY button as many times
as necessary until the required start de-
lay appears on the display, e.g.
if the programme is to be star-
ted in 12 hours.
3. To activate the delay timer, press the
START/PAUSE button. The amount of
time remaining until the programme is
set to start is continuously displayed
(e.g.
If the display is showing
and you press the button again, the
time delay will be cancelled. The dis-
play will show
of the selected programme.
CHILD LOCK
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child safety device locks all
buttons and the programme knob. The
child safety device can be activated or deac-
tivated by holding down the BUZZER and
TIME buttons simultaneously for 5 seconds.
• Before programme is started: Appliance
cannot be used
• After programme is started: Programme
in operation cannot be changed
The symbol appears in the display to in-
dicate that the child safety device is activa-
ted. The child safety device is not deactiva-
ted once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
right level of dryness is reached, the Iron
Aid programme will start automatically. The
steam indicator shows the progress of the
Iron Aid programme in the display. The indi-
vidual steam phases are shown by anima-
ted clouds of steam.
,
, ...
and then the duration
,
etc).