Changing Motor Protection Filter; Epa-Filter Change - Fakir Range Electronic Bedienungsanleitung

Changing motor
protection filter

EPA-Filter change

Cleaning an Maintenance
ATTENTION!
If the motor protection filter contained in the package
of replacement dust bags is too big, cut it precisely to
the dimension required for your vacuum cleaner. Make
sure that the motor protection filter fits perfectly the
opening of the vacuum motor and does not allow any
dust to get in.
To open the cassette cover strech from the middle
point of cassette locking hole in the direction of arrow
and pull cassette cover slowly. Cassette cover should
be removed from the place it has been mounted
easily. After cassette cover is removed, pull holding
ring to remove black sponge filter and white filter.
Wash the filters under warm tab water -dirty side
looking downwards- gently and make sure they are
completely dry before placing them inside the casess-
te filter according to grouping instructions.
Notice!
Change cycle, motor protection filter - after the con-
sumption of approx. 5 dust cups.
The EPA-filter is located under the exhaust air grid on
the rear of the appliance.
1. Release the exhaust air grid.
2. Remove the old EPA-filter and replace it by a new
one.
3. Reinsert the exhaust air grid until it clicks into
place.
Notice!
Change cycle, HEPA-filter after approx. 6 months.
17