Changing The Dust Bag; Changing The Motor Protection Filter - Fakir Prestige C 240 8901 Bedienungsanleitung

Changing the dust bag

L
S
T
U
Changing the motor
protection filter
V
W
V
After use
● Lift the catch of the dust chamber lid [L].
● Open the dust chamber lid [S] – you will hear it click into
place.
● Remove the full dust bag [T] from the holder [U] by pulling
in the direction of the arrow.
● Insert the new bag [T] completely into the holder [U] in the
direction shown by the arrow.
● Press down the dust chamber lid [S], until it clicks into pla-
ce.
NOTE!
If the dust bag is not in place or not in the correct position,
the lid block (holder) will prevent the dust chamber lid
[S] from closing correctly. Always ensure that all the filters
are inserted before you use the vacuum cleaner.
The motor protection filter is located behind the dust
bag in the dust chamber.
● Open the dust chamber lid and remove the dust bag (see
"Changing the dust bag").
● Push the motor protection filter-cassette [V] as far up as
possible until you can remove it.
● Remove the motor protection filter [W] from the cassette
and insert a new filter.
● Push the motor protection filter-cassette [V] back down in-
to the guide rails again.
● Reinsert the dust bag and close the dust chamber lid.
NOTE!
Change cycle, after approx. 5 dust bags.
Kapitel R
GB
35