miniland baby digimonitor 8" plus Bedienungsanleitung Seite 16

To disable this function and view the monitored area continuously you must select
CAMERA mode on the camera.
5.2.1.2. Night Light OFF AUTO ON
When in the switch (9) is ON position, the night light will be ON continuously.
When it is switched to AUTO position, it will only be ON only when it is triggered
by sound. When it is switched to OFF position, the night light will be turned off.
5.2.1.3. Volume (High- Mid - Low)
(13) It is used to adjust the sound volume on Baby unit at a preferred level.
5.2.1.4. Transmission HI/LOW
(8) When it is switched to HI position, it can reach 300m in open field with its
original transmitting power. Whereas it is switched to LOW position, the transmitting
distance is about 150m in open field.
5.2.1.5 Channel linking:
This product is designed to allow monitoring different areas with up to 4 cameras
(Channel 1, 2, 3 or 4 assigned to different cameras). The original monitor and
camera are already set on Channel 1 by manufacturer at factory. If you need to
add extra new camera for monitoring, you need to choose a new channel to 'link'
the new camera with existing monitor.
1 Plug the USB receiver into the monitor (photo frame). Turn ON the camera.
Place them not more than 2 feet apart.
2 Choose your preferred channel by pressing Chanel selection button in the
USB receiver.
3 Press and hold on the Channel selection button until the red LED starts blinking.
4 Keep pushing the hidden Linking button through the small hole at the back of the
camera by using a pin. The Power LED Light will start flashing indicating the
linking process; linking between the camera and the monitor unit is undergoing.
5 Linking is successful when your live image can be seen on the monitor screen.
At this moment the power LED on the Camera stops flashing and the camera unit
and the monitor unit work well together.
- Repeat the above process to connect additional cameras (up to 4 cameras).
1 2
English
2
3