Werbung
Control panel
a. "ON" indicator light
b. Light ON-OFF button
c. Motor OFF button
d. e. f. Motor speed buttons
speed 1 (d.), speed 2 (e.), speed 3 (f.)
Use of the hood
It is advisable to switch on the extractor
hood a few minutes before starting cooking
and then to leave it running for approximately
5 minutes afterwards to ensure that all odours
are extracted.
Maintenance
Before performing any maintenance
operation, isolate the hood from the
electrical supply by switching off at the
connector and removing the connector fuse.
Or if the appliance has been connected
through a plug and socket, then the plug
must be removed from the socket.
Metal grease filter
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at least
once a month.
Let the filter dry without damaging it before
putting it back into place.
When washed in a dish-washer, the grease
filter may discolour slightly, but this does
not affect its filtering capacity.
To remove the metal grease filter - Fig. 2:
1. Disconnect the hood from the electricity.
2. a - push toward the centre
b - pull the filters downwards.
Carry out the above steps in reverse order to
put the filters back after having washed
them.
Carbon filter
("recirculation mode only", see next pages)
The carbon filter cannot be washed nor
regenerated.
- Fig. 1 -
GB
The carbon filter should be replaced every
6 months under normal use.
To fit the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Fit the carbon filter and fix it to the body of
the hood with two supplied screws
4. Put the metal filter back into place.
To replace the carbon filter - Fig. 3:
1. Disconnect the hood from the electricity.
2. Remove the metal filters.
3. Remove the old carbon filter and replace
it.
4. Put the metal filter back into place.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents. Never use products
containing abrasive.
Wipe brushed stainless steel in the same
direction as the brushing to avoid scratching.
Attention
Failure to observe the instructions for
cleaning the appliance and changing and
cleaning the filters may cause fires.
Therefore, we recommend observing these
instructions.
Replacing the lamp - Fig. 4
1. Disconnect the hood from the electricity.
Firstly check that the lamps are well
cooled prior to replacing them.
2. Unscrew the lamp cover.
3. Replace the damaged lamp with a new
halogen lamp of 20Watt max.
4. Screw the lamp cover on its proper place.
Before calling for repair service because
the hood fails to light up, make sure the
lamps are well inserted.
5
Werbung
