Inserting And Disconnecting The Carrier Battery; Inserting And Disconnecting The Downtube Battery; Parametrisataion Of Control - HEINZMANN DirectPower Einbauanleitung

GB

3.6 Inserting and disconnecting the carrier battery

3.7 Inserting and disconnecting the downtube battery

3.8 Parametrisataion of control

Installation instructions drive set DirectPower
 Push the battery into the luggage carrier on the slide rail from behind.
The lock engages audibly at the stop. The electrical connection is
given additional support from the magnetic force in the plug.
 To disconnect and remove the battery, turn the key on the left side of
the luggage carrier clockwise and hold. Then release the battery from
the connection by pulling hard on the handle and pull out of the
luggage carrier to the back.
CAUTION:
Only insert the battery once the system has been completely
installed! When commissioning for the first time after
installation or repair, set up the bicycle so that the drive
wheel can turn freely!
Before riding allways lock the battery and take off the key!
 Place downtube battery onto the mounting rail so that the contacts
point towards the controller box. Feathers of mounting rail have to fit
into gaps at the bottom of the downtube battery.
 Push the downtube battery onto the controller box. The lock engages
audibly at the stop. The electrical connection is given additional
support from the magnetic force in the plug.
 To disconnect and remove the battery, turn the key on the left side of
the luggage carrier clockwise and hold. Then release the battery from
the connection by pulling it back, away from the controller box.
Take off the battery vertcally to downtube.
CAUTION:
Only insert the battery once the system has been completely
installed! When commissioning for the first time after
installation or repair, set up the bicycle so that the drive
wheel can turn freely.
Before riding allways lock the battery and take off the key!
 For parameter setting see separate manual on supplied CD
respectively
13