Mounting The Control Housing - HEINZMANN DirectPower Einbauanleitung

GB

3.5 Mounting the control housing

3.5.1 Version with carrier battery
Control unit
3.5.2 Version with downtube battery
Installation instructions drive set DirectPower
The controller box is mounted on the luggage carrier close to the saddle.
It is already prepared for the electrical connection of the components. All
cables are already led out. Except the cable for bicycle lighting all are
fitted with plug connectors.
These are:
> Display
> Torque sensor
> Motor supply cable
> Motor signal cable
> Bicycle lighting
> Cable for the regeneration signal from the brakes, where
applicable
 Screw the controller box onto the luggage carrier.
2 pcs. M4×16 countersunk-head screw, through the slide rail from
below.
Mounting torque: 1 Nm ± 0.1 Nm
1 pc. panhead screw, self-cutting, through the housing section into the
slide rail from above (see Fig.).
NOTE:
Installation of a downtube battery requires definite dimen-
sions of the bicycle frame. See following figure for details!
Required space for installation of
downtube battery in a bicycle frame
10