Mounting The Display And Control Unit - HEINZMANN DirectPower Einbauanleitung

GB

3.4 Mounting the display and control unit

Installation instructions drive set DirectPower
 Push the sensor disk onto the bottom bracket shaft.
IMPORTANT: Note the direction of rotation of the sensor disk
(arrow). The sensor disk should run true and without any 'wobble' if
fitted properly. Mind minimum dimensions of the square taper.
 Mount chain and crankset
(see manufacturer information for torque settings).
Fit chain guard, if any.
The control unit can be mounted either on the left side or the right side or
even in the middle of the handlebar. The control elements (e.g. gears)
may have to be mounted on the opposite side. The fixing clamp is
available for handlebar diameter Ø22 mm or Ø31,8 mm optionally.
 Remove the handles on the handlebar, along with any switch or
control elements.
 Fix the control unit on the handlebar using the mounting clip. The
centre button must be positioned so that the "Mode" label is legible
and not upside down.
The control unit can be mounted on the right or left side of the
handlebar as desired. The display is positioned to the right or left of
the centre of the handlebar depending on the cable length.
 Fix the display on the handlebar using the mounting clip.
 Mount the switch or control elements again and re-attach the
handlebar handles.
9