Mounting The Motor - HEINZMANN DirectPower Einbauanleitung

GB
M

3.2 Mounting the motor

Installation instructions drive set DirectPower
 First of all, fix the slide rail onto the luggage carrier with three
countersunk-head screws M4×18, nuts and washers in the assembly
holes (M).
Mounting torque: 1.4 Nm ± 0.1 Nm.
 Mount the luggage carrier on the bicycle.
Once complete, the packing area should be horizontal.
Set the head stay mountings (K) accordingly to align the luggage
carrier.
CAUTION:
All screw connections on the luggage carrier must be
secured!
We recommend: Loctite 221
CAUTION:
The motor may only be installed in forks or frames, which
are approved by the manufacturer for use with electric
auxiliary drives!
Fork or frame must have sufficiently measured dropouts to guarantee a
secure and reliable mounting of the motor axle and in particular the
torque support. Between the drive wheel nuts and the dropouts of frame
or fork a whasher has to be installed on each side.
Tightening torque of the drive wheel nuts during installation:
The torque support must be completely surrounded by the dropout.
The recess (A) of the torque support must always point to the open side of
the dropout!
The torque support must be mounted completely free from play.
The dimensions and tolerances from the current valid customer drawing
from HEINZMANN must be complied with!
NOTE:
The mounting screws of brake disc might abrase the motor cable.
Therefore the motor cable should be fixed to the motor axle with
a cable tie.
When running the motor cable at the frame, make sure that there
is a bend in cable looking downward. This shall prevent e.g.
rainwater to get into the motor or the plug along the cable.
45 Nm ± 5 Nm
7