Audio-Technica M3 Einrichtung Und Betrieb Seite 8

8
How to make setting changes on the M3R Stereo Receiver
To access the M3R Stereo Receiver's user-changeable functions, Touch
the Set button. The top line of the transmitter display shows "FREQ" .
Touch the Down arrow button to scroll through the functions that may
be changed. (See the chart below.)
To change a receiver function, when the function to be edited is displayed,
touch the Set button. (Note: When the M3R Stereo Receiver is first
powered on, the LCD's timed backlight is on. After the backlight
has timed out, a touch of the Set or Up/Down arrows turns the
light on again. In this case, you will need to touch the Set button
twice in order to change a receiver function, since the first touch
will simply turn the backlight on.)
M3R Stereo Receiver Functions
Function Menu
▲▼ Frequency
▲▼ Group
▲▼ User
▲▼ Scan **/***
▲▼ Limiter
▲▼ Squelch
▲▼ Mode
▲▼ Output
▲▼ Aux level
▲▼ Mic Volume (if Aux set to Mic)
▲▼ Program
▲▼ Reset
▲▼ Quit (exit Menu)
* Continue in the same Up/Down direction and choices "wrap around" to the other end of the range.
The small word "EDIT" will appear in the display. Touch the Up/Down
arrow buttons to scroll through the available choices for the function,
stopping on the desired choice. Hold the Mode/Set button to accept the
new choice. "STORED" appears in the display when the choice is
accepted. The receiver then returns to Menu mode. Continue this
process until all desired function-setting changes are complete. Note:To
escape from Edit mode without making any changes, touch the
Mode/Set button. "ESCAPE" appears briefly in the display, and the
receiver returns to Menu mode.
Default Value Choices (Edit)
Lowest in band Over 1250 discrete frequencies
G1 - 1 G1 – G6 (16 channels each)
U1 - 1 U1 – U3 (16 channels each)
No value Scan start
3 (maximum limiting) 3, 2, 1, Off
0 Off, -1, 0, 1, 2
Stereo Stereo, Mono
Stereo Stereo, L/R Mix
Line Line, Mic
1 1 – 16
- Create custom frequency groups
Choose OK to restore factory settings
QUIT Press Mode/Set once to exit
Wrap-around*
Yes
Yes
Yes
--
Yes
No
Yes
Yes
Yes
No
Continued on page 9