Audio-Technica M3 Einrichtung Und Betrieb Seite 5

M3T Transmitter Controls
(front panel)
1
2 3
1. Power switch. Depress once to turn on. Depress again to turn off.
2. Headphone output. / " TRS jack provides monitoring of audio feed
1
4
at the transmitter. Plug in either a mono or stereo headphone.
3. Headphone level control. Adjusts level of monitor headphones;
affects 1 / " headphone jack only. Does not affect transmitter audio
4
output.
4. Liquid crystal display. Indicates control settings and operational
readings. It is also used with the Mode/Set and Up/Down arrow
buttons to change user-configurable functions. See page 7 for details.
5. Up/Down buttons. Use with the Mode/Set button to step through
menus, select operating frequency and edit receiver function choices.
6. Mode/Set button. Use with the Up/Down arrow buttons to step
through menus, choose operating frequency and select receiver
function options.
Two distinct operations are associated with this button:
Touch: A momentary press of the Mode/Set button is used to
enter Menu mode, to enter Edit mode, or to Escape without
making any changes to current settings.
Hold: A press and hold (about two seconds) of the Mode/Set button
is used to accept a new setting when the receiver is in Edit mode
or to save the current settings.
7. Detachable flexible antenna. Detachable antenna transmits to
receivers.
7
4 5 6
(rear panel)
9 9
8
8. Data port. For factory use only.
9. Loop output. The R/2 XLR jack duplicates the unprocessed signal
of the R/2 input; the L/1 XLR jack duplicates the unprocessed
signal of the L/1 input. Not affected by front panel settings.
10. Attenuators. Offer -20 dB, -10 dB, and 0 dB attenuation for each
input.
11. Inputs. Combination input jacks offer both XLR and
12. DC input. Plug the included power supply in here.
13. Cord hook. Loop the small DC cord around the cord hook to keep
the DC plug from pulling out accidentally.
Phantom power
The transmitter does not provide phantom power, but it does allow
phantom power to pass through from your phantom power supply to a
device plugged into either input jack.
CAUTION: If connecting instruments to a mixing console through
the transmitter loop output, then use a direct box to prevent
damage to your instruments and/or equipment from the mixing
console's phantom power; i.e. hook your instrument into a direct
box, then hook your direct box into the transmitter.
5
10 1 1
10 1 1
13
12
1 / " jacks.
4
EN