Hitachi RAF-25QH8 Bedienungsanleitung Seite 18

2. HOW TO INSTALL AND REMOVE THE FRONT PANEL
• Be sure to use both hands to grasp the front panel when removing it or attaching it.
• The front panel may be installed up or down to suit user preference.
Removing
1 Press the hook found at the tip of the resin band
installed inside the front panel's right section to
remove the resin band.
Attaching
1 Attach three front panel bearings to the axis of
the front cover. (Set the hook to face up.)
3. CLEANING OF FRONT PANEL
The front panel can be washed in water. It can be kept clean at all times.
• Front panel can be removed and washed in water. Gently clean the
front panel using a soft sponge.
• When the air conditioner is to be cleaned without removing the front
panel, clean both the body and remote controller with a dry soft cloth.
• Wipe off water completely. If water remains on the display section or
light receiver section, this could cause a malfunction.
CAUTION
• Do not splash or direct water to the body of the unit when cleaning it as this may
cause short circuit.
• Never clean with hot water (above 40°C), benzine, gasoline, acid, thinner or a
brush, because it will damage the plastic surface and the coating.
4. MAINTENANCE AT BEGINNING OF LONG OFF PERIOD
• Activating air conditioner drying will keep the interior of the indoor unit
dry and prevent mold formation.
• Turn off the circuit breaker.
Front cover
Resin band
Hook
Front panel
– 18 –
2 Pull the front panel down toward you and once
fully open, pull it to remove.
2 Insert the tip of the resin band into the hole of the
protrusion inside the right section of the front
panel.
Resin band
A
C
I
D
Air blow