Nibe SMS 40 Installateurhandbuch Seite 19

SMS command for settings changes
The following command can be used when you want to make changes in your climate unit via SMS 40:
Caution
The change command that is sent to SMS 40 must always be written with a space between the command
and the desired value.
If you want to activate "Temporary lux, hot water" for 12 hours for example, you send the SMS message
"!tlhw 12"
The command is answered with a status message.
Command Parameter
!op 0/1
!tlhw 0/3/6/12
!reg1 -10–10
!reg2 -10–10
!reg3 -10–10
!reg4 -10–10
!roomt1 5–30
!roomt2 5–30
!roomt3 5–30
!roomt4 5–30
!vac 1/0
!alarm
!vent 0/1/2/3/4
1) Accessories are required
2) Applies to F370, F470, F730 and F750
3) Applies to F1145/F1155 and F1245/F1255
4) Applies to F1345/F1355
5) Before activating the holiday setting, you must select, in the climate unit, what is to occur when holiday mode is activated. For further
information, see the installation manual for your climate unit.
SMS 40 | GB
Answer Description
?status Change operating mode
Auto/add. heat only
?status Temporary lux, hot water. 0/3/6/12 hours.
?status Temperature (offsetting the heat curve in systems without
room sensors)
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 2
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 3
?status Temperature (offsetting heat curve in systems without room
sensor), climate systems 4
?status Temperature (setting the room temperature in systems with
room sensors)
?status Temperature (setting the room temperature in systems with
room sensors), climate system 2
?status Temperature (setting the room temperature in systems with
room sensors), climate system 3
?status Temperature (setting the room temperature in systems with
room sensors), climate system 4
?status activating/deactivating holiday settings
Resets alarm
Changed fan speed. 0= normal fan speed
1)
1)
1)
1)
1)
1)
5)
2), 3+1), 4+1)
19