Zippie RS Benutzerhandbuch Seite 36

Tilt (Fig. 9.6 - 9.7)
The seat angle is adjustable between -5° - 40°.
When activating the tilt-lever (A ) you are able to tilt the base
(Fig. 5.01), to the required position.
When you let go of the lever the seat will remain in the chosen
position.
DANGER!
• Use caution when tilting as it is possible that the fingers can
become trapped.
• There must be some play in the cable for the mechanism to
work correctly.
• Avoid tying the cable too tightly.
• Avoid kinking the cable.
• The tilt mechanism should only be adjusted by authorized
dealers.
Adjustable backrest: (Fig. 9.8)
When activating the recline levers (A-B) you are able to recline
the backrest. When you let loose the backrest will be fixed in
that position.
DANGER!
• We recommend to use the recline with anti-tip tubes
• Do not recline the back backwards while standing on an in- or
decline.
Height adj. push-handle (Fig. 9.9 - 9.10)
Loosen the star grip screws (1).
Adjust the height of the push-handles.
Ensure that the star grip screws are fully tightened after
adjustment.
CAUTION!
If the push-bar tubes are pulled too far out of the back tubes,
they will automatically lock in position. To release them, push
the push-bar tubes back inside the back tubes, (3) and push
them down. Secure the push-bar by tightening the star grip
screws.
DANGER!
If the star grip screws are not tightened the user can be injured
while being lifted.
Angle adjustable push bar
By loosen the clamp lever, (2), the angle/height of the push-bar
can be adjusted. Tighten the clamp lever afterwards.
DANGER!
It clamp levers are not tightened the user can be injured while
being lifted.
36
Fig. 9.6
A
Fig. 9.7
A
Fig. 9.9
2
1
Fig. 9.10
2
Zippie RS Rev.1.0
Fig. 9.8
B
3