Zippie RS Benutzerhandbuch Seite 27

• Before setting off, check that your tyre pressure is correct. For
rear wheels it should be at least 3.5 bar ( 350 k Pa). The max.
Pressure is indicated on the tyre. The knee-lever brakes will
only work if there is sufficient tyre pressure and if the correct
setting has been made (see the Chapter on "Wheel locks").
The wheel locks are not intended to brake your wheelchair.
They are only there to ensure that your wheelchair does not
begin rolling unintentionally. When you stop on uneven
ground, you should always use the wheel locks to prevent
such rolling. Always apply both wheel locks; otherwise, your
wheelchair could tip over.
• Always make use of elevators and ramps. If these are not
available, you should request the help of an attendant. They
should only grip the wheelchair at securely mounted parts. If
anti-tip tubes are fitted these must be folded away. A
wheelchair should never be lifted with an occupant; it should
only be pushed.
• If the seat and back plate are damaged, you must replace
them immediately.
• Do not lift or carry the wheelchair by the back tubes or the
push handles.
• Do not fit any unauthorised electronic equipment, powered or
mechanically operated mobility drives, hand-bike or any other
device that changes the intended use or the structure of the
wheelchair. Any combination with other medical devices
requires the approval of Sunrise Medical.
• Be careful with fire, in particular with burning cigarettes.
• If and whenever possible, during a journey in a specially fitted
vehicle for disabled people, vehicle occupants should use the
seats in the vehicle and the appropriate restraint system. This
is the only way to ensure that occupants will have the
maximum protection if there is an accident. When using safety
elements offered by SUNRISE MEDICAL and using a
specially designed safety system, lightweight wheelchairs can
be used as a seat when being transported in a specially fitted
vehicle. (See the Chapter on "Transportation").
• Always make sure that the quick-release axles on the rear
wheels are set properly and lock in. If the button on the quick-
release axle is not pressed in, the rear wheel cannot be
removed.
• In particular when using lightweight metal hand rims, fingers
will easily become hot when braking from a high speed or on
long inclines.
• If the wheelchair is subject to direct sunlight for a long period
of time, then parts of the wheelchair (e.g. frame, leg rests,
brakes and side guard) may become hot (>41°C).
• To avoid hand injuries do not grab in between the spokes or
between the rear wheel and wheel lock when driving the
wheelchair.
• Do not use the wheelchair on slopes > 10°.
• The Dynamic safe slope is dependent on the chair
configuration, the users abilities and the style of riding. As the
users abilities and style of riding cannot be predetermined
then the max safe slope cannot be determined. Therefore this
must be determined by the user with the assistance of an
attendant to prevent tipping. It is strongly recommended that
inexperienced users have Ant-tips fitted. Do not use your
wheelchair on muddy or icy ground. Do not use your
wheelchair where pedestrians are not allowed.
• With all moving parts there is a natural risk of finger traps.
Please handle with care
• The wheelchair should not be used in heavy rain, snow,
slippery, or unsound surfaces. Do not use the wheelchair in
hazardous environments.
Zippie RS Rev.1.0
DANGER!
CHOKING HAZARD – This mobility aid uses small parts which
under certain circumstances may present a choking hazard to
young children.
NOTE:
• The effect of the knee-lever brake as well as the general
driving characteristics are dependant on tyre pressure. The
wheelchair is significantly lighter and easier to manoeuvre
when the rear wheels are pumped up correctly and both
wheels have the same pressure.
• Make sure that your tyres have sufficient tread!
• Please note that you are subject to any and all traffic laws
when driving in public traffic.
• When it is dark, please wear light clothing or clothing with
reflectors, so that you can be seen more easily. Make sure
that the reflectors on the side and back of the wheelchair are
clearly visible. We would also recommend that you fit an active
light.
• Always be careful with your fingers when working or adjusting
the wheelchair!
The products shown and described in this manual may not be
exactly the same in every detail as your own model. However,
all instructions are still entirely relevant, irrespective of detail
differences.
The manufacturer reserves the right to alter without notice any
weights, measurements or other technical data shown in this
manual. All figures, measurements and capacities shown in this
manual are approximate and do not constitute specifications.
Lifetime
The expected lifetime of this product is 5 years.
27