Controls And Indicators - Candy GrandO GOV 580C Bedienungsanleitung

Start/Pause
Button
Control Panel and Indicator Lights
Programme Selector – Select the required
programme
Delay Start button
delay the start of the drying cycle (see details
of Operation on page 10)
Start/Pause button
commence the selected drying programme
Acrylics Synthetics
to reduce the heat level for delicate items,
the indicator above the button will light up. To
change the heat setting the programme must
be reset
Low Heat – Indicator light ON
High Heat – Indicator light OFF
Filter Care indicator
filter needs cleaning
Progress display
DRY – When the programme is selected the
DRY indicator will flash, when the programme
starts the DRY indicator will light up.
– Indicator lights when there is a short
time left until completion of the programme. At
this stage of the drying cycle the machine
enters the Cool Down phase.
The length of the Cool Down phase varies
between 10 and 15 minutes depending on the
programme.
END – Indicator lights when the programme
is finished.
EN 8

CONTROLS AND INDICATORS

Filter Care
Indicator
Progress
Display
– Allows the user to
– Press to
button – Press
– lights when the
Acrylics/Synthetics
Button
Delay Start
Button
SELECTING THE PROGRAMME
The Candy Sensor Dry machine gives many
options for drying the laundry to suit all
circumstances.
The table on the next page lists the program-
mes and the function of each programme.
Note: The sensor may not detect a small load of
small articles. For small loads and separate
items or pre-dried fabrics with low moisture
content, use the timed programmes.
Set the programme between 30 and 75 minutes
depending on the load size and dryness
required, and select high or low heat depending
upon the fabric type.
If the sensor does not detect the item the dryer
will only operate for 10 minutes before going
into cooldown.
If the load is too large or too wet to tumble dry
the dryer will automatically go into cooldown
after approximately 3 hours.
Programme
Selector