pewag snox SXP Montageanleitung Seite 8

Mounting
Make sure that the blue lock (quick release) is closed – green
1
car visible in the window (see flag 1).
Pull the red ring near the red box (see flag 2) apart. Put the
2
red box from the top over the tire. The red box must be positi-
oned on the inner side of the tire.
Pull the red ring (in the area of flag 3) down firmly using both
3
hands. Position the red ring as far as possible behind the
tire. Take care that the blue clips – on the red ring – are not
twisted.
Pull the red ring down until it is positioned between the tire
4
and the street (see flag 3). Take care that the plastic clips do
not lay on the tread on top of the tire.
Drive your car forward or reverse it by 1/4 a rotation of the
5
wheel (wheels may not spin). Recommendation: Move the
vehicle downhill.
Move the red ring completely to the inner side of the tire. The
6
chain must be arranged correctly (not twisted). Take care that
the blue clips – on the red ring – are not twisted.
7 This is how the chain looks when it is mounted correctly. Drive
a few meters at walking speed. Recheck for a correct fit of the
chain after approx. 50 m.
MOUNTING COMPLETED
E
Demounting
Stop your car in such a way that the blue lock (quick release)
1
is on top. Press the red latch – a car crossed-out in red is
visible.
Grab the chain in the area of the tire tread and pull it firmly to
2
the front (release chain strings if they are jammed in the tread
of the tire).
3 By pulling firmly, the red ring slips from the rear side to the
front.
4 Pull the chain in front of the tire. Take care that the chain is not
twisted at the drive-off area. Drive the car forward or
reverse it slightly. Recommendation: Close the blue lock
(quick release) for the next use.
DEMOUNTING COMPLETED