Replacing The Lamp - Electrolux ENN2872BOW Benutzerinformation

Problem
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.

7.2 Replacing the lamp

CAUTION!
Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover
with your fingers to unlock it. Remove
the cover by pulling it towards
yourself.
Possible cause
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
2. Replace the lamp with one of the
3. Install the lamp cover.
4. Connect the plug to the mains
Solution
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
1
2
1
same power and shape, specifically
designed for household appliances.
The maximum power is shown on the
light bulb cover.
socket.
ENGLISH 13