Weight Defrost Function - Sharp R-343 Bedienungsanleitung

OTHER CONVENIENT FUNCTIONS
3. CHILD LOCK:
Use to prevent unsupervised operation of the oven by children.
a. To set the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 3 seconds. There will be a long beep de-
noting entering the children-lock state and the
the current clock time. If the clock has not been set the display status will be as follows:
b. To cancel the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 3 seconds. There will be a long "beep"
denoting that the lock is released.
Mode
4. ECO :
In standby mode, press the "STOP" button once, the LED display will be off and microwave
oven enter to ECO mode. Any operation can light the LED display again, and the microwave
oven will return to standby mode.

WEIGHT DEFROST FUNCTION

WEIGHT DEFROST
The microwave oven is pre-programmed with a timer and power levels so that foods such
as pork, beef and chicken can be easily defrosted. The weight range for this is from 100g –
2000g in 100g steps.
Follow the example below for details on how to operate this function.
Example: To defrost a meat joint weighing 1.2Kg using WEIGHT DEFROST.
Place the meat in a fl an dish or alternatively on a microwave oven defrost rack on the turn-
table.
1. Press the
WEIGHT DEFROST
button once.
NOTE:
• Frozen foods are defrosted from -18°C.
• Before freezing foods, ensure food is fresh and of good quality.
• If necessary, shield small areas of meat or poultry with fl at pieces of aluminium foil. This
will prevent the areas from becoming warm during defrosting. Ensure the foil does not
touch the oven walls.
• Food weight should be rounded up to the nearest 100g, for example, 650g to 700g.
• After defrosting an audible signal will sound five times and the LED will then display
time of day, if the clock has been set. If the clock has not been set, the display will only
show "0:00" when defrosting is complete.
2. Enter the desired weight
by rotating the ENTRY
dial until the display
shows:
GB-19
indicator will illuminate together with
3. Press the START/+30sec./
ENTER button to start
defrosting.
(The display will count
down through defrosting
time)