50% Capacity; Safety Features - SKF TIH 240 Bedienungsanleitung

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop

3.6 50% capacity

The power should be reduced to 50% when using smaller yokes than
standard (available on request) or when extra care has to be paid to
avoid excessive heating.
Bearings with brass cages should also be heated on 50% capacity.

3.7 Safety features

The induction heater is equipped with the following safety features:
– Main switch with overload circuit breaker.
– Automatic overheating protection.
– Electronics protected by fuses.
– In the TEMP MODE the heater will be switched off if the temperature
probe does not register a temperature increase of
1 degree every 60 seconds.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
SKF TIH 240 13