Linksys X6200 Benutzerhandbuch Seite 190

• Network Name (SSID)----- -The Service Set Identifier (SSID) is the network name
shared by all devices in a wireless network. It is case-sensitive and must not
exceed 32 keyboard characters. The default is Linksys followed by the last 5 digits
of the router's serial number, which is found on the bottom of the router. If you
used the setup software for installation, then the default Network Name is
changed to an easy-to-remember name.
Note—If you restore the router's factory default settings (by pressing the Reset
button or using the Administration > Factory Defaults screen), the Network Name
will return to its default value, and all devices on your wireless network will need to
be reconnected.
• Security Mode----- -See Security Modes
• Channel Width----- -For best performance in a network using Wireless-B, Wireless-G
and Wireless-N devices, select Auto (20 MHz or 40 MHz). For a channel width of
20 MHz, select 20 MHz only.
Standard Channel----- -Select the channel from the drop-down list for Wireless-B,
•
Wireless-G, and Wireless-N networking. If you are not sure which channel to select,
then keep the default, Auto.
• SSID Broadcast----- -When wireless clients survey the local area for wireless
networks to associate with, they will detect the SSID broadcast by the router. To
broadcast the router's SSID, keep the default, Enabled. If you do not want to
broadcast the router's SSID, then select Disabled.
5 GHz wireless settings
• Network Mode----- -Select the wireless standards your network will support.
Mixed If you have Wireless-A, Wireless-AC and Wireless-N (5 GHz)
-
devices in your network, keep the default, Mixed.
Wireless-A Only----- -If you have only Wireless-A devices, select Wireless-A
-
Only.
Wireless-N Only----- -If you have only Wireless-N (5 GHz) devices, select
-
Wireless-N Only.
Wireless-AC Only----- -If you have only Wireless-AC (5 GHz) devices, select
-
Wireless-AC Only.
Wireless-A/N Only----- -If you have both Wireless-A and Wireless-N devices in
-
your network, select Wireless-A/N Only
Wireless-N/AC Only----- -If you have both Wireless-N and Wireless-AC devices
-
in your network, select Wireless-N/AC Only
Disabled----- -If you do not have any Wireless-A, Wireless-AC and Wireless-N
-
(5 GHz) devices in your network, select Disabled.
Note—If you are not sure which mode to use, keep the default, Mixed.
(p. 19).
18