Linksys X6200 Benutzerhandbuch Seite 182

Internet Setup > Internet Connection Type
3. In the
IPoE (dynamic or static IP address) as required by your ISP (check with your
provider's helpdesk if you're not sure). Select Bridge Mode only to use the unit as a
modem without router functionality (i.e., without Wi-Fi or any other network
functions).
If using PPPoE, enter the correct username and password as specified by
•
your ISP.
• If your connection type is Dynamic, select
Type
, and for IP Settings select
If your ISP requires IPoE with a static IP address, select
•
Connection Type
address settings (given to you by your ISP) in the fields provided.
4. Click Save Settings (at the bottom of the page) to save settings and complete
setup.
Automatically obtain an IP address
Use the Following IP Address
, then select
section select either PPPoE, or
IPoE Internet Connection
for
IPoE
for
and enter the IP
.
Internet
10