Error Messages - Sony PXW-X70 Bedienungsanleitung

Error Messages

When problems occur during network client mode/USTREAM operation, the following error
messages may be displayed. Take measures depending on the displayed message.
Also refer to "Error messages" in "Firmware update" (Ver. 2.00).
Error message
Cannot authenticate with WEP.
The password is wrong or automatic acquisition of
an IP address has failed.
Cannot authenticate with WEP.
The password is wrong or the IP address setting is
wrong.
Cannot execute functions.
Failed to connect to the CCM.
Check the "CCM SET".
Failed to acquire an IP address.
Check the DNS server setting or the "CCM SET".
Failed to connect to the CCM.
Check "CCM SET" or the settings of the
connection destination.
Failed to connect to the CCM.
Check the "CLOCK SET".
Failed to connect to the CCM.
Failed to connect to the Ustream server.
Check the "CLOCK SET".
Ustream error occurred.
User name or the password is invalid.
The server rejected the request.
Authentication information is invalid.
Check the user name and password.
An invalid channel has been specified.
Connection to the server terminated.
Check the communication environment.
There is a possibility that the movie was not saved
correctly on the server.
GB
12
Solution
Check the password (WEP key). Check the DHCP
settings of the access point.
Check the password (WEP key). Check the IP
address setting of the camcorder.
Restart the camcorder. If the problem persists,
contact a service representative.
(NETWORK SET) t [NETWORK
Check
CLIENT MODE] t [CCM SET] settings.
Check that the CCM host name is correct. Check
the DNS settings of the camcorder and access
point.
Check the CCM setting of the camcorder, and the
user name, password, port number and other
settings of the connected destination. Also, check
the network connection status.
Check that the camcorder clock is set to the correct
time.
Check the camcorder settings and the status on the
CCM side.
Check that the camcorder clock is set to the correct
time.
Try to restart streaming. Check the status of the
USTREAM service.
(http://www.ustream.tv/)
There may be an input error in the user name or
password. Check that the entered user name and
password are correct.
Try to restart streaming. Check the status of the
USTREAM service.
(http://www.ustream.tv/)
(NETWORK SET) t [USTREAM]
Check
t [USER INFO SET] settings.
Specify a valid channel and try to restart streaming.
Reconnect using a stable communications
environment.
Check whether or not the movie was saved on the
server.