Axis Q1614-E Montageanleitung Seite 24

AXIS Q1614-E Network Camera
1. Optionally insert an SD memory card (not included) into the SD card slot. A standard or
high capacity SD card is required to store images locally in the camera.
2. Optionally connect external input/output devices. See Connectors on page 17 for
information on the connector pins. See Route the Network Cable Through the Cable Hole
on page 20 for information on preparing the network cable. Route the cables through
the cable holes into the bottom cover and to the camera.
3. Connect the camera to the network using a shielded network cable and using the
network connector (PoE IN) on the bottom cover. The network cable and the I/O cable
between the bottom cover and the camera, are already connected at delivery.
4. Check that the indicator LEDs indicate the correct conditions. See LED Indicators on
page 13 for further details.
Adjust Focus
To adjust the zoom and focus follow these instructions:
Note
• Set the focus as precise as possible with the focus puller or Focus Assistant before starting
automatic fine tuning. Using the focus puller normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of field and thus the best conditions for correct focusing.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers (see Hardware Overview on page 10) on the lens by
turning them counter-clockwise. Move the pullers to set zoom and focus and check the
quality of the image in the image window.
If the camera is mounted so that one cannot look at the image and move the pullers at
the same time, use the Focus Assistant instead.
5. Re-tighten the zoom and focus pullers.
6. On the Focus page, click Fine-tune focus automatically and wait until automatic fine
tuning is completed.
7. Click Enable iris. If the button is inactive the iris is already enabled.
8. If needed, make further adjustments under the Advanced tab. See the online help for
more information.
24